Announcement

Collapse
No announcement yet.

HR10-250 Tuner Question

Collapse
X
Collapse
 
  • Page of 1
  • Filter
  • Time
  • Show
Clear All
new posts
Previous template Next
  • #1

    HR10-250 Tuner Question

    I have a question about the HR10-250 I hooked up. I have inputs going to Sat1 and the OTA antenna. I don’t have the Sat2 input connected yet, because I need to run another cable from the dish.
    When I check System Information, only one of the OTA tuners is enabled. I can’t find anyway to enable the second tuner. Does the Sat2 have to be connected to enable the second OTA tuner?
    The DVR is running Rev 3.1.5f-01-02-357.
    It’s been activated for two weeks but hasn’t updated 6x
    Bill
    Tags: None
  • #2
    Nope - never seen that. What exactly does it say in the information screen?

    Internally, you can disconnect each OTA tuner. Maybe one is disconnected?
    Been here a long time . . .

    Comment

    • #3
      Page 2 of the Service Information screen looks like this:
      --------------------------------------------------------------------------

      DVR Service: Active
      Tuner List: DIRECTV 1 (Sat1): Enabled
      DIRECTV 2 (Sat2): Not Enabled
      ATSC 1 (Ant In): Enabled
      ATSC 2 (Ant In): Not Enabled
      Recording Capacity: Variable, up to 30 HD or 200 SD hours
      Program Source: Satellite and off-air antenna
      --------------------------------------------------------------------------

      I took the cover off and both tuners are connected to the splitter.
      Bill

      Comment

      • #4
        OK - then it sounds like one ATSC tuner is dead, somehow. There's a first for everything.
        Been here a long time . . .

        Comment

        • #5
          My Atsc tuner is dead too, anybody figure out why?

          Comment

          Previous template Next
          Working...
          X