I have a series 1 Tivo that had a 40 gig drive that I upgraded a few yrs. ago. I saved the factory image to a cd and used that image to upgrade the new drive,so I know the image is good.
Now,the problem
I have a series 2 that the drive went bad in. So I tried to install the S1 image to a new drive and expands and says what the hours are,etc. When i put it in the S2 I get the welcome Powering... screen,than a grey screen . I also have a S2 image that I've had for awhile and it does the same thing. I type
mkdir /mnt/dos
mount /dev/hda1 /mnt/dos
mfsrestore -s 127 -xzpi /mnt/dos/tivo.bak /dev/hdb
Then it will uncompress,do the clean up,tell me the new hours,etc. I also tried -xzbpi since I cant recall which MFS tools I used ...last one I did was 2004 and not sure if I'm missing something. Thank you for any help
Now,the problem
![Confused](https://www.wkforums.com/forums/core/images/smilies/confused.png)
mkdir /mnt/dos
mount /dev/hda1 /mnt/dos
mfsrestore -s 127 -xzpi /mnt/dos/tivo.bak /dev/hdb
Then it will uncompress,do the clean up,tell me the new hours,etc. I also tried -xzbpi since I cant recall which MFS tools I used ...last one I did was 2004 and not sure if I'm missing something. Thank you for any help
Comment