I had successfully installed the SWM switch to connect 2 HD recievers and 1 HD DVR reciever in my house. thanks to this forum. thanks.
my previous setup
four cables from Satelite to SWM-8 in basement.
from the SWM1 port a 8 foot cable to PI SWM port
from PI IRD port 4 foot cable to 1-4 splitter
1-4 spliter
output 1 to basement tv HD reciever 5 feet away
output 2 to living room a first floor HD DVR 30 feet away.
output 3 to attic 1-4 splitter 80 feet away.
output 4 is capped.
1-4 splitter in attic has output 1 to bedroom HD reciver.
i added one more TV on the second floor. from the output 2 in the attic 1-4 splitter.
all recievers lost satellite signal.
so I changed out the basement and living room reciever to the SWM2 output to isolate the upstairs TV's. i used the PI on the cable to the attic splitter.
I got the first HD reciever to get a signal, but the new reciever can not pickup a satellite signal. and now i'm getting signal interuption on my living room tv also.
when i test the signal strength of the new reciever i get these results (i switch out the recievers and got the same results on a different reciever)
101 - no signal
110 - no signal
119 - no signal
99(c) - 95% signal
99(s) - no signal
103(s) - 95% signal
103(c) - 95% signal
SWM - 95% signal
I think i've isolated the problem to the long run of cable from the basement to the attic splitter or the attic 1-4 splitter. I changed the cable end connectors in the attic to make sure it wasn't that.
have i missed something?
can all these reciever work off the SWM1 output with the original setup?
any help would be appriecated.
thanks
my previous setup
four cables from Satelite to SWM-8 in basement.
from the SWM1 port a 8 foot cable to PI SWM port
from PI IRD port 4 foot cable to 1-4 splitter
1-4 spliter
output 1 to basement tv HD reciever 5 feet away
output 2 to living room a first floor HD DVR 30 feet away.
output 3 to attic 1-4 splitter 80 feet away.
output 4 is capped.
1-4 splitter in attic has output 1 to bedroom HD reciver.
i added one more TV on the second floor. from the output 2 in the attic 1-4 splitter.
all recievers lost satellite signal.
so I changed out the basement and living room reciever to the SWM2 output to isolate the upstairs TV's. i used the PI on the cable to the attic splitter.
I got the first HD reciever to get a signal, but the new reciever can not pickup a satellite signal. and now i'm getting signal interuption on my living room tv also.
when i test the signal strength of the new reciever i get these results (i switch out the recievers and got the same results on a different reciever)
101 - no signal
110 - no signal
119 - no signal
99(c) - 95% signal
99(s) - no signal
103(s) - 95% signal
103(c) - 95% signal
SWM - 95% signal
I think i've isolated the problem to the long run of cable from the basement to the attic splitter or the attic 1-4 splitter. I changed the cable end connectors in the attic to make sure it wasn't that.
have i missed something?
can all these reciever work off the SWM1 output with the original setup?
any help would be appriecated.
thanks
Comment